Explora Solda e outros!

Explorar tópicos relacionados

Solda Cáustico | Página 4203

Solda Cáustico | Página 4203

Wandtattoo freches Kätzchen - Bild 3

Wandtattoo freches Kätzchen - Bild 3

Name: Fancy Tiger Crafts Location: 59 Broadway, Denver, Colorado Size: 4,000 square feet Years worked in: 2 years Fancy Tiger Crafts is kind of like a knitwear wonderland. With wall to wall shelves of wool and felt yarns being stocked by lovely ladies in hand-crafted sweaters, it's definitely a place a shopper can really escape to for a while. But it's not just a great little shop: it's a community classroom for sewers, knitters and crafters of all skill levels.

Fancy Tiger's Crafty Cute Shop and Classroom — Workspace Tour

Name: Fancy Tiger Crafts Location: 59 Broadway, Denver, Colorado Size: 4,000 square feet Years worked in: 2 years Fancy Tiger Crafts is kind of like a knitwear wonderland. With wall to wall shelves of wool and felt yarns being stocked by lovely ladies in hand-crafted sweaters, it's definitely a place a shopper can really escape to for a while. But it's not just a great little shop: it's a community classroom for sewers, knitters and crafters of all skill levels.

This is an antique windmill that is 8 ft across with a barn board center and Edison light bulbs we hung from our dining room ceiling.  Damn, my hubby's handy.

This is an antique windmill that is 8 ft across with a barn board center and Edison light bulbs we hung from our dining room ceiling. Damn, my hubby's handy.

Chaveiros, Chains

8'windmill ceiling fan for our living room. This fan was made by me. It has a gear driven motor that has so many different programs that it would take too long to explain. The frame support I fabricated out of 1.5" angle iron and steel plates. The trusses were cut down to fit our ceiling girts, then welded in place. The original fan shaft was used and I drilled holes through it to install safety pins on the two ball bearings so in case the bearings went out the fan won't fall.

8'windmill ceiling fan for our living room. This fan was made by me. It has a gear driven motor that has so many different programs that it would take too long to explain. The frame support I fabricated out of 1.5" angle iron and steel plates. The trusses were cut down to fit our ceiling girts, then welded in place. The original fan shaft was used and I drilled holes through it to install safety pins on the two ball bearings so in case the bearings went out the fan won't fall.

Romance Colecção | Noun Project

Romance Colecção | Noun Project

Pinterest
Pesquisar